Springfield Armory Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
here is the deal I bought a new hammer and beaver tail and mag release ambi thumb safety mag well and plug and slide release all in stainless steel. I like to customize my guns, I thought it was drop in stuff but was I wrong! now I have to pay a gunsmith to do this that sucks!
 

Attachments

·
Registered
Joined
·
13 Posts
Nice gun! Everything listed there except for the beavertail safety can be fit to the gun by you if you are patient and have some mechanical aptitude. Regardless of what
anyone says, except for the spring plug nothing is truly "Drop in" on a 1911. Everything takes fitting to some extent and if you have any concerns that you cant do it by all
means have a smith do it for you. The cost to fit everything you listed should not be an enormous bill. The beavertail looks strange and I assume it already had a beavertail
on it and your just changing finishes. A Smith and Alexander piece would have the right radius for your gun, Wilson combat and others like it will not fit without a lot of work.
It should look really nice when your done!!
 
1 - 3 of 3 Posts
Top