Springfield Armory Forums banner

1 - 3 of 3 Posts

·
Registered
2021, Ronin 9mm, 5”
Joined
·
14 Posts
Discussion Starter · #1 ·
Disassembled my new Ronin 9mm. Everything went fine until reassembly. Can’t get the slide locking pin back in. I’ve watched 10 videos on take down, cleaning and reassembly without success. No problem lining it up but can’t get past the safety pin. Somebody help.
 

·
Junior Member
Joined
·
100 Posts
You can take something (non scratching and non puncturing in case it slips) and depress that part where it's hanging up. Hold it in and push in the slide locking pin. It will slip by and capture that part and then click in place.
 

·
Registered
2021, Ronin 9mm, 5”
Joined
·
14 Posts
Discussion Starter · #3 ·
You can take something (non scratching and non puncturing in case it slips) and depress that part where it's hanging up. Hold it in and push in the slide locking pin. It will slip by and capture that part and then click in place.
thanks...dummy me put the idiot scratch on already but used your trick and I now have a working gun.
 
1 - 3 of 3 Posts
Top