VIEW MY

megafiddle

Member

Join Date:

10-10-2015

Last Activity:

09-10-2017 12:04 AM

Likes Given: 6

10 Likes on 8 Posts 

LATEST ACTIVITY

  • Posted in thread: MantisX on 08-30-2017 at 12:49 PM
    Still not sure if I completely understand this piece of equipment.:confused:Someone want to
    take a shot at it.https://www.usacarry.com/mantisx-firearms-training-system-review/It's an
    interesting use o...

  • Posted in thread: MantisX on 08-30-2017 at 12:07 PM
    Thank you, Megafiddle!Hope it was helpful. As you say, you don't really need it to tell you are
    wandering off target. For dry fire, you can simply watch the sights, and for live fire, you can
    simply l...

  • Posted in thread: MantisX on 08-25-2017 at 04:39 AM
    Interesting tech, but I don't need 1 $149 device to tell me that I am less steady than a vice.
    Anyone know the "wall drill" mentioned in the article?I've used the wall drill occasionally,
    though I did...

  • Posted in thread: Testing Mechanical Offset on 08-19-2017 at 12:06 AM
    Hope the numbers are useful. Although approximate, I believe they are accurate to within 0.1".
    The article, while generally correct, seems to mixing together the effects from two different
    rifles.The ...

  • Posted in thread: Swab-Its Gun Cleaning products on 08-15-2017 at 11:41 PM
    I like that chamber swab. Something I discovered: CITMED Cotton Tail swabs. These are 6" long
    Q-tip type cotton end on a wooden stick. Perfect size for .22 pistol and revolver barrels.

  • Posted in thread: Testing Mechanical Offset on 08-15-2017 at 10:44 PM
    The mechanical offset applies to iron sights as well. The only difference with an optical sight
    is that these often sit even higher than iron sights, and so the offset can be as much as 3"
    with optica...

  • Posted in thread: EMP4 CCC malfunctions on 05-29-2017 at 01:40 AM
    It sounds like the extractor is fine then. The slight angle of the empty case should be of no
    concern, especially since the live round sits straight. Perhaps the primer is protruding
    slightly, and hol...

  • Posted in thread: EMP4 CCC malfunctions on 05-28-2017 at 07:52 AM
    I would also agree that Springfield should take care of an uneven breechface if that is indeed
    the problem. I believe these are cut vertically with a broach, and can leave vertical tooling
    marks. I ha...

  • Posted in thread: The "NEW" XD-E on 05-26-2017 at 10:55 PM
    As I have aged, and shoulder replacement, has reduced my upper body strength, to the point that
    I find it very difficult to rack the slide. My Shield, is almost impossible, and the XDM is
    somewhat bet...

  • Posted in thread: Magazine Springs and Pouches on 05-26-2017 at 10:33 PM
    If the tops of the magazines are identical, with all the same latching points, then the older
    covers should fit.The covers don't allow magazines to be loaded for longer periods. They
    prevent the cartr...

0 COMMENTS
POST A COMMENT